Side sliding beds

While converting as many vans as we have, we realised that the traditional rock and roll beds can limit the layout and design within some vans. With this in mind, we have developed a side sliding bed system that can be fitted to any base vehicle.

SAM_0019 SAM_0238 SAM_0081

General specification

The bed/seat slides side ways to create a bed supported on two fixed legs. The entire top can be lifted, with the aid of a gas strut to allow access for storage. The top is fitted with sprung wooden slats for comfort. Each bed is made to your specification and is powder coated in satin black.

  • Frame manufactured from 25 x 25 x 2mm  and 50 x 25 x 2mm thick box section steel
  • Most popular length is 1830mm long (6ft), can be made to any length,
  • Most popular height is  380mm high (15″), can be made to any height.
  • There are three most common widths:

Narrow    - closed (seating position) is 615mm and 1110mm (bed position)

Standard - closed (seating position) is 665mm and 1160mm open (bed position)

Wide        - closed (seating position) is 715mm and 1210mm open (bed position)

All sizes are approximate

  • A good quality gas strut to support the top when open
  • All ends are finished with black plastic end caps (where applicable)
  • Sprung laminated beech slats in natural colour
  • Brown slat end pockets
  • Standard finish is powder coat satin black but other colours are available.

This is a quality bed/seat that we have used in many of our own campervan conversions. The usual positioning is behind the driver seat, but could be modified to fit almost anywhere in your van. This bed/seat also gives you an opportunity to have a different layout to the usual side cabinet/rock n roll bed.

Prices on application

SAM_0045 SAM_0046 SAM_0047
SAM_0050 SAM_0052 SAM_0053